Mirror Projection for False Ceiling
Cinema Mirror, is an optical-active set to be installed in false ceilings hiding the projection equipment and that has an opening and closing of the 335x335 mm hatch, allowing the projection of the image, thanks to its two mirrors, without causing any effect. trapeze. For this, the Cinema Mirror and the screen must be in the same plane or with a difference of 0 to 12 cm max. Now it is possible to control the opening and closing of the mirror separately, so system integrators can know where the device is. There are even more advantages, since the projector remains perfectly protected, against dust, dirt and possible theft; furthermore, the noise from the projector is not transmitted to the audience. We recommend projectors with a throw projection ratio greater than 1.5: 1.
- Supply: 230 VAC / 50Hz.
- Power: 10 W
- Starter (switch not included): Double switch / 1 A to 230 VAC
- Noise level: < 15 dB
- False ceiling minimum height: From 170 mm to 217 mm
- Maximum height of floodgate slope: 265 mm
- Mirror opening time: 30”
- Motor reducer: 500/1
- Minimum dimension of the hole to embed: 335 mm x 335 mm
- Mechanical Dimensions (mm): LONG 625 / WIDE 395 / HIGH 170
- Max load acceptable: 5,0 Kg
- Net weight: 8.2 Kg
- Gross weight with packing: 12.3 Kg
- RF remote control included
Data sheet
- Location
- Ceiling
- Equipment
- Projector
- Acondicionamiento
- Electric
- Max Weight
- 30 or less
You might also like